MerCruiser Intake Manifold Installation

Pre Intake Manifold Install
April 13, 2021

Pre MerCruiser Intake Manifold Installation This is the process of preforming MerCruiser Intake Manifold installation. Firstly, there are two Manifolds because there is an upper and lower intake. Before installing the lower intake, we have to finish setting the valve lash. Below is a chart I found of what valves have to be adjusted depending on whether cylinder one is a Top Dead Center (Black Circles) or Cylinder Six (Ed…

Read More >>

MerCruiser Port Head Reinstallation

MerCruiser 5.7 Cylinder Head Refreshed
April 6, 2021

Steps to MerCruiser Port Head Reinstallation In preparation for MerCruiser Port Head Reinstallation Firstly , we have finished installing the Starboard Cylinder Head. It’s the same process for the Port Cylinder Head as with the Starboard Cylinder Head This is the process of the MerCruiser Port Cylinder Head Reinstallation. Secondly, I made a mistake and did not read the instructions for torqueing the head bolts. Thirdly, there is an additional…

Read More >>

210 Select Electrical Rewiring

Horn, Starboard Docking Lights Re-Installed
April 4, 2021

We are starting some of the easy stuff related to the 210 Select electrical rewiring. First, we are going to focus on the horn, docking lights and navigation lights. They are at the front of the boat and I need to determine if I have to re run new wiring. Up to this point I have been primarily working on the engine. I spent several hours cleaning out cylinder head…

Read More >>

Vortec Head Tech

Vortec Rocker Arms
April 1, 2021

So this post is all about Vortec Head Tech 101. I’ve learned a lot about this engine, especially around these Heads. So as I was installing the heads I ran into a bit of a conundrum while putting the rocker arms on the studs. Vortec Head Tech 101 First, Carefully look at the top picture. This picture was taken before the starboard head was removed. Secondly, you will see that…

Read More >>